Follow us
GATE PI Question Paper 2023GATE PI Question Paper 2023: The Production and Instrumentation exam of GATE 2023 has been conducted on February 11, and the overall difficulty level of the exam was 'Moderate'. The question paper of GATE PI 2023 is a combination of MCQs, MSQs and NAT questions. The candidates must note that the General Aptitude section in the Production and Industrial Engineering question paper consists of 15 marks while the subject-based questions are for 85 marks. As the mode of GATE PI 2023 is online, the candidates can download the memory-based question paper of GATE PI 2023 along with the solutions and answer key.
| Latest: GATE 2023 Result Live |
|---|
GATE PI Official Question Paper and Answer Key 2023
The official GATE PI question paper 2023 with the answer key will be released on February 21 by IIT Kanpur, and the candidates will be able to download the same in PDF format at gate.iitk.ac.in.
GATE PI Official Answer Key 2023 |
|---|
GATE PI Response Sheet 2023
The official GATE PI response sheet 2023 will be released on February 15, and the candidates are required to download the same through the GOAPS portal of the GATE website 2023.
| GATE Response Sheet 2023 Live |
|---|
Also read| GATE Question Paper 11 February 2023
GATE PI Question Paper 2023 PDF (Memory-Based)
The memory-based GATE PI Question Paper 2023 are being updated here as and when we receive questions from test takers.
GATE PI Questions 2023 |
|---|
Wooden cubical block of .1 meters has specific Gravity of 75. It is held in a submerged pool of oil and water. What is the tension 'T' in newton in the wire? |
| Current 4500 A, Time.02 second, resistance 400 X 10 (to the power of -6) ohms and Thermal Efficiency was 50%. Find the Heat Input. |
| Under steady-state conditions there is a turbine where in the inlet the enthalpy is 3200 kilojoule per KG. Heat loss is 100 Kilo joule per KG. and the turbine work is 1000 kilo joule per KG. What will be the dryness fraction? |
| If reynolds no.=1000,d=10mm,density=1.5 and thermal conductivity=0.66 w/k then find coefficient of |
| The total number of nonconformities is 420 from 30 samples. The size of each sample is 100. The lower control limit for the control chart for number of nonconformities is (round off to 2 decimal places). |
| Two metal sheets are joined using resistance spot welding. A welding current of 4500 A is applied for 0.2 s. The effective contact resistance at the sheet interface is 400 x 10^-6. The thermal efficiency of the welding process is 50%. The amount of heat. in J. used for producing a spot weld is (in integer). |
| The standard time for completing a job on a machine is 10 minutes. Number of machines available is 5, each machine is available for 300 hours/month, and average machine utilization is 80%. The maximum number of jobs that can be produced in a month is (in integer). |
Also read| GATE Physics (PH) Question Paper 2023
For the latest Education News , keep visiting CollegeDekho.
